These instructions will guide you through setting up Bridged mode on your Huawei HG659 router.
Before you begin:
- We do not guarantee this functionality because the compatibility of the third party router you wish to bridge to the Voyager Huawei router will be a significant factor.
- You'll need your Voyager username (@vygr.net) and password which can be located on the email we had sent to you earlier with the subject "PROV-xxxxx: Broadband Configuration Details"
- You will need to be connected to the modem's WiFi or (recommended) have a computer with an Ethernet cable plugged into one of the four yellow “LAN” ports on the back of the router.
- The following steps are for the Voyager retailed Huawei HG659 router. If you have a Huawei HG659 router from another internet service provider, the setup process may be different.
Logon to the Huawei HG659 Web Interface using your web browser: http://192.168.1.1
Enter the administration username and password for your router to login
- Default user name is: !!Huawei
- Default password is: @HuaweiHgw
| 1. | From the top menu, click 'Internet' |
| 2. | Click 'Internet Settings' from the left side menu |
| 3. | Then click the 'Edit' button under 'VOYAGER_VDSL' |
| 5. | Un-tick Service types 'TR069' and 'VOICE' (5) |
| 6. | From the 'Connection type' drop down menu select 'Bridged' (4) |
| 7. | Click Save. |
| 8. | Configure the Voyager VDSL PPP configuration with VLAN tagging disabled on the WAN interface of your third party router.
|
| 9. | Connect an Ethernet cable from any (Yellow) LAN port on the Voyager Huawei Router to the WAN port of your third party router. |
Please Note: Our scope of support is limited for non-Voyager retailed hardware.
Get in touch
For any additional help, give us a call on 0800 477 333 (8AM to 10PM, 7 days a week).